FD

“The Dairy Cheq® milk monitoring and reporting system has become an essential tool in managing our dairy. It tracks so much more than we were aware of when we first purchased it. We recommend the Dairy Cheq® system to anyone concerned with the efficiency and safety of dairy operations.”

Dave Cary of Cary Dairy

FD

FD

The next generation in Dairy Cheq® MilkGuard products is available NOW.

The Dairy Cheq® MilkGuard FD is the most flexible Dairy Cheq® MilkGuard yet with improved the user interface and more features.

New in the Dairy Cheq® MilkGuard FD:

  • Larger Screen provides more detailed information to the dairy farmer when reviewing daily operating information or alarm information.
  • Wash History: Tank and Pipeline wash temperatures are now available for 30 days without using the Dairy Cheq® MilkGuard Software.
  • Enhanced Communication is now available using Bluetooth, WiFi, or GPRS modems

Each Dairy Cheq® MilkGuard FD comes with a set length of 50 feet/ 15 meters of wire, a tank sensor, a vacuum sensor, a pipeline sensor and one alarm light.

MilkGuard FD

How does it work?


Low temperature for pipeline cleaning

This alarm occurred following a pipe cleaning that was not hot enough. The pipeline wash had a maximum temperature of 39.2°C (103°F).  The target wash temperature of 40°C (104°F) for 4 minutes was not met, so the alarm occurred.

Possible Causes of the Low Temperature Pipecleaning Alarm may be:

  • Water heater is starting to fail
  • Pipe wash not started
  • Wash valves not in proper position
  • Pre cooler still running during the wash
  • Plugged screen in wash circulation loop
  • Not enough water volume to maintain temperature
  • Mixing valve adding cold water during hot cycle
  • Faulty check valve


Milk Too Warm

If the milk is not cooled within the required time (or regional requirement), then a “Regulatory” or rule-based condition has been breached.

The Dairy Cheq® MilkGuard FD will give the dairy farmer a warning 10 minutes after milking if cooling is not sufficient to meet the regulation.  If the milk is not cooled to below 5°C (Canada) or 45°F (US) quickly enough, then a “Regulatory” alarm will occur.

Possible Causes of the Slow Cooling Alarm may be:

  • Not enough cooling capacity
  • Failed compressor
  • Cooling efficiency is gradually degrading
  • Radiator needs to be cleaned
  • Leak in freon line
  • Thermostat has failed
  • Thermostat is not set to proper temperature


Switch on Cooler

If the milk cooling equipment is not turned on for the first milking, an alarm will occur.

The Dairy Cheq® MilkGuard FD looks for a temperature drop to detect cooling.

Possible Causes of the Switch on Cooler warning may be:

  • Forgot to switch on cooler
  • Failed compressor
  • Freon leak in cooling lines